General
- Does Heatmiser do a hard wired controller that can do heating and hot water?
- My Floor Is not warm enough
- Can you use a neoStat HC for a fan coil unit and wet underfloor heating?
- Can you put a combination of wired and battery powered thermostats to a UH8?
- How to change Smart Start wiring to the neoStat WIFI
- I need to put more than 8 thermostats on one manifold
- Can a neoStat V2 be used to control Hot Water?
- Can I use my Heatmiser controller for an Immersion?
- Do neoStats need to be connected to a wiring centre to connect to the neoHub?
- Can I wire actuators into an RF Switch?
- What cables do I need to connect my thermostats?
- What does LS and LR mean?
- How do I wire a manifold valve to my UH4
- The output is volt free what does this mean?
- Can the UH8 work with 2 port valves and provide a volt free boiler enable switch?
- Can I use a Heatmiser neoStat to control the hot water tank or must I use a neoStat HW with the Heatmiser UH4?
- I have a UH4/UH8 and I have more than 4 actuators on one zone, what can I do?
- Does the neoHub boost the signals between thermostats and wiring centre ?
- How many actuators can I connect to a zone?
- What is the replacement for the UH1 Wiring Centre?
- What is the replacement for the UH3 Wiring Centre?
- How do radiator zones on the Heatmiser wiring centres enable the boiler?