If you cannot see Edit on a neoStat, it means that it is in non programmable mode, in other words, it is a manual controller.
Usually you can see only the power icon and HOLIDAY.
If you wish to put it into programmable mode have a look at the following
If you have the 'Heatmiser Neo' App.
- On the App, go to Settings and go to Programmable Mode and change the setting from there.
If you do not have App control
neoStat V2/neoAir V2/neoAir V3 (white screen)
- Go to the power icon on the left
- Press and hold tick until you see SETUP
- Press tick
- Press the up arrow to make the small number 12
- Use the left and right keys as follows
- 01 5/2 mode (weekend and weekdays are different)
- 02 7 day mode, (all days different)
- 03 24 hour mode, (every day the same)
- Press Tick
neoStat V1/neoAir V1 (blue screen, SETUP on the bottom right hand side).
- Use the right arrow to go to SETUP
- Press tick
- Press the up arrow to make the small number 12
- Use the left and right keys as follows
- 01 5/2 mode (weekend and weekdays are different)
- 02 7 day mode, (all days different)
- 03 24 hour mode, (every day the same)
- Press Tick