On the Touch RF
- Press PROG
- Press SETUP
- Change the small number to 06
- Change the large number to 01
- Press DONE
On the UH8-RF V2, press and hold the zone that you wish to pair on the UH8-RF V2 for 5 seconds until the light flashes.
On the Touch RF, press SCREEN for 5 seconds
The thermostat will send a signal and show “PAIR RF” & the RF icon in the display
If pairing is successful, the zone light will go out.
Then turn the heating up on the thermostat. After around 20 seconds, the zone light should come on the UH8-RF V2